Just like the steel wire, the steel mesh will also be bent and deformed, which will undoubtedly bring difficulty to the cutting and easily lead to poor cutting quality. Moreover, after the steel mesh is cut, if you want to restore the original state, you need to knock with a sledgehammer to correct the shape.
Cutting requirements of bending deformed steel mesh: try not to buy when the steel plate has been rusted or deformed and bent.
The bending and deformation of the steel plate mesh will increase the difficulty of cutting, which is easy to cause poor cutting quality. After the steel plate mesh is cut, it needs to knock and calibrate the shape with a sledgehammer to provide the cutting program for the NC cutting machine. The NC cutting machine is used for cutting all the time, not for programming. The pickling passivation paste is not omnipotent.
The steel plate cutting of steel plate mesh is difficult to remove the black oxide scale produced by plasma cutting and flame cutting.
Pickling and passivation treatment is carried out after manual grinding and polishing. For workpieces with large area, it is difficult to achieve uniform treatment effect, and the ideal uniform surface can not be obtained.
In addition, the labor cost and the auxiliary material cost of steel mesh are also high, including handicraft manufacturing, good speaker net cover, highway guardrail, stadium fence and road green belt protective net.
Although there are only four words in steel plate processing, it contains a lot of relevant knowledge. Therefore, based on this point, the next step is to elaborate and explain the relevant knowledge of steel plate processing, so that everyone can have a correct understanding through learning. Steel plate zero cutting knows what it is and how to carry out it smoothly, so as to avoid various problems in the operation process.
1. For steel plate processing, whether different processing types correspond to different processing processes and steps.
For steel plate processing, different processing types correspond to different processing processes and processing steps. Therefore, we can know that the answer to this question is yes. Moreover, we need to determine which processing to carry out first, and then determine the specific processing processes and processing steps. The order cannot be reversed, otherwise there will be problems.
2. Whether the processing of steel plate is the same as that of stainless steel plate.
Strictly speaking, steel plate processing and stainless steel plate processing cannot be equated with steel plate processing, because in terms of scope, the scope of the former is wider than that of the latter. Moreover, steel plate processing includes the processing of stainless steel plate, and they can be said to be subordinate. Therefore, the above conclusion can be reached.
3. Whether the processing of iron red rusted steel plate belongs to steel plate processing, and whether the calculation of steel plate processing cost should be carried out correctly.
The processing of iron red rusted steel plate belongs to steel plate processing, so it is certain that the answer to question 1 is yes, and there is no doubt about it. The calculation of steel plate processing cost should be carried out correctly, so as to obtain accurate values. Then, the correct results can be obtained through calculation and avoid getting wrong results due to wrong calculation.
The above is the detailed introduction of Jinan steel plate cutting and processing factory. I hope it will help you If you have any questions, please contact us We will provide you with professional service http://www.msmpoz.com